CT-354 Cellular Telephone
(170-1065/1070/1165)       Access Programming

ACCESS NAM PROGRAMMING MODE:

1.  Turn the phone on.

2.  Enter the NAM access code.  Factory default is:     *3001#12345

3.  Press [OK].

4.  Verify that the display goes blank.  If "NOT ALLOWED" appears, check
    to see if you have entered the access code correctly.  You may verify
    that NAM Programming has been entered successfully by pressing the
    (symbol) key.  In the upper right hand corner you should see n1
    through n6. If you do not see the "n" appear, NAM programming has not
    been entered correctly.  Try again.

    Note:  If "NOT ALLOWED" appears after a few programming attempts the
           access code has been changed or an error has occurred and the
           phone will have to be returned to Nokia for repair.

ENTER SPECIAL NAM PARAMETERS (Memory Location 01):

5.  Press and hold the [CLR] key until the display clears.

6.  In one long string, enter the special NAM parameters according to the
    format of Example 1 below.  Enter each emergency number (such as 911)
    followed by the pound (#), the Language Code followed by the asterisk
    (*) key, and the desired five-digit Security Code.  Language Codes:
    0-English, 1-French, 2-Spanish, 3-Portuguese.

    NOTE 1 Emergency numbers entered in memory location 01 can be used
           while call restrictions are active and when the phone is
           locked.

    NOTE 2 The first number entered in the list of emergency numbers is
           used for the speed dial (9) key. 

EXAMPLE 1:    911 # * 911 # 0 * 1234

7.  Enter [OK] 01 [OK].

ENTER MOBILE PHONE NUMBER (MEMORY LOCATION 02 OR 04):

8.  Press and hold the  [CLR] key until the display clears.

9.  Enter the correct 10 digit phone number.  A wake up text message may
    be added by pressing the [ABC] key and entering the desired message
    from the keypad.

10. (For Primary NAM) Enter [OK] 02 [OK].

    (For Optional NAM) Enter [OK] 04 [OK].

ENTER SYSTEM PARAMETERS (MEMORY LOCATION 03 OR 05):

1.  Press and hold the [CLR] key until the display clears.

2.  In one long string enter the system parameters according to the format
    of Example 2 below.  Be sure to separate each parameter with an
    asterisk (*) or pound (#) as shown below.  Do not place an asterisk
    before or after the string.

Example 2:    34 * 1 * 1 * 334 * 15 * 15

    (For Primary NAM) Enter [OK] 03 [OK].

    (For Optional NAM) Enter [OK] 05 [OK].

VERIFY NAM INFORMATION:

1.  Press and hold the [CLR] key until the display clears.

2.  Use the key and location number to check locations 01 through 05.  Do
    not program anything to location 06.

3.  Verify that the information for each memory location is correct.

4.  To exit the programming mode, power the phone off then back on.  If
    "NAM ERROR" appears on the display, programming was done incorrectly
    and must be repeated.

(08/14/96)